top of page
2GR  3D Prinnted Intake Manifold Testing

This page is to document  my 3D printed intake manifold info

This 1st intake was printed on a Bambu X1C using ASA filament. I printed it in multiple sections due to print bed size and bonded it with homemade ASA goo . Finished parts were painted with 2k clear for further chemical resistance. 

 I designed this intake using the calculators from Bain Racing.  Testing the stock variants , the over ported lower, and  aftermarket offerings made it apparent that better performance could be had with some further testing.  Below you will find pics off my 1st iteration and DynoJet  results to compare to my previous tests.  Engine is a stock longblock  2GRFE with longtube headers, electric water pump, E75, ID1300 injectors at 60psi, FT600 ECU, Tuned by Hux Racing. 
20261110_131552.jpg
20261110_124810.jpg
20261110_124825.jpg
3D printed intake.png
3D Printed Intake Dyno Results. My best Power to date. 
#4  vs 3d.png
3D Printed vs My #4 intake with ported lower
3D vs #4 versions.png
3D Printed vs My #4 intake with ported lower vs #4 with overported lower and 83mm TB
3d vs fmw.png
I added this compare cause I knew you would ask for it. 
  • Grey Facebook Icon
  • Grey YouTube Icon
  • Grey Instagram Icon
bottom of page